Gate Safety Reversing Edge Assembly
Courion Part Numbers Available:
REV-STD (Standard NEMA 1 rating)
REV-HAZ (NEMA 7 & 9 – hazardous location)
REV-WET (NEMA 4, 12, & 13 – dust, moisture, & oil resistant)
The length of the Gate Safety Reversing Edge Assembly is dependent on the width of your Car Gate Panel. To insure that you receive the correct replacement part, please contact one of Courion’s Customer Service Representative prior to ordering.
Gate Reversing Edge - Hazardous Locations
07-700025
SJO Cord Assembly (25′)
18 Gauge, 3 Wire
NOTE: SJO Cord with four (4) wires is required for NEMA 4 tape type reversing edges.
Where Used: REV-STD, REV-HAZ
90-854700
Latex Rubber Tubing (Cut-to-Length)
Where Used: REV-HAZ
90-854900
Rubber Hose
Where Used: REV-HAZ
90-855200
Neoprene (Cut to Length)
Where Used: REV-HAZ
90-959000
Neoprene – 1″ x 1″ (Cut to Length)
Where Used: REV-HAZ
90-960100
Nipple
Where Used: REV-HAZ
90-982600
90-982602
Reversing Edge Micro Switch – N.O. (hazardous location)
Where Used: REV-HAZ with Model “D” Door Control
Reversing Edge Micro Switch – N.C. (hazardous location)
Where Used: REV-HAZ with Model “E” Door Control or Model “MP” Door Control
09-102201
Rubber Bumper
(1-1/4″ x 1-1/4″ thick)
Where Used: REV-HAZ
Gate Safety Reversing Edge Assembly
REV-KIT
Gate Panel Reversing Edge Kit
This Kit includes all of the parts necessary to replace a Courion Gate Safety Reversing Edge Assembly except the Gate Channel and electrical boxes. Assembly is required.
Where Used: REV-STD
07-600200
Contact Case Cover
Where Used: REV-STD
07-600700
Reversing Edge Insulator
Where Used: REV-STD
07-689701
Trip Wire Spring
Where Used: REV-STD
08-500300
08-500300S
Contact Lever Spring
Contact Lever Spring (stainless)
Where Used: REV-STD, XFE, XFM
09-102200
Rubber Bumper (1-1/2″ x 5/8″ thick)
Where Used: REV-STD
11-204801
Contact Lever
Where Used: REV-STD
20-006011
Neoprene (Cut-to-Length)
Where Used: REV-STD
90-000500
Dead End Bolt
Where Used: REV-STD
90-807700
Nylon Bushing
Where Used: REV-STD
90-875300
Reversing Edge Micro Switch
Where Used: REV-STD
90-878500
Pressure Lug Wire Clamp
Where Used: REV-STD
90-887900
Trip Wire (Cut-to-Length)
Where Used: REV-STD
07-700025
SJO Cord Assembly (25′)
18 Gauge, 3 Wire
NOTE: SJO Cord with four (4) wires is required for NEMA 4 tape type reversing edges.
Where Used: REV-STD, REV-HAZ