Gate Panel Reversing Edge Kit

This Kit includes all of the parts necessary to replace a Courion Gate Safety Reversing Edge Assembly except the Gate Channel and electrical boxes. Assembly is required.

Where Used: REV-STD

Contact Case Cover

Where Used: REV-STD

Reversing Edge Insulator

Where Used: REV-STD

Trip Wire Spring

Where Used: REV-STD

SJO Cord Assembly (25')

18 Gauge, 3 Wire

NOTE: SJO Cord with four (4) wires is required for NEMA 4 tape type reversing edges.

Where Used: REV-STD, REV-HAZ

Contact Lever Spring

Contact Lever Spring (stainless)

Where Used: REV-STD

Rubber Bumper (1-1/2" x 5/8" thick)

Where Used: REV-STD

Contact Lever

Where Used: REV-STD

Neoprene (Cut-to-Length)

Where Used: REV-STD

Dead End Bolt

Where Used: REV-STD

Nylon Bushing

Where Used: REV-STD

Reversing Edge Micro Switch

Where Used: REV-STD

Pressure Lug Wire Clamp

Where Used: REV-STD

Trip Wire (Cut-to-Length)

Where Used: REV-STD

Gate Safety Reversing Edge Assembly - Hazardous Location

The length of the Pneumatic Gate Safety Reversing Edge Assembly is dependent on the width of your Car Gate Panel. To insure that you receive the correct replacement part, please contact one of COURION's Customer Service Representive prior to ordering.

SJO Cord Assembly (25')

Where Used: REV-STD, REV-HAZ

Rubber Bumper (1-1/4" x 1-1/4" thick)

Where Used: REV-HAZ

Latex Rubber Tubing (Cut-to-Length)

Where Used: REV-HAZ

Rubber Hose

Where Used: REV-HAZ

Neoprene (Cut to Length)

Where Used: REV-HAZ

Neoprene - 1" x 1" (Cut to Length)

Where Used: REV-HAZ

Nipple

Where Used: REV-HAZ

Reversing Edge Micro Switch - N.O. (hazardous location)

Where Used: REV-HAZ with Model "D" Door Control

Reversing Edge Micro Switch - N.C.
(hazardous location)

Where Used: REV-HAZ with Model "E" Door Control or Model "MP" Door Control